 |
|
  |
|
 Hamilton Drywall
Products is proud to introduce Prep Coat Plus "Level 5" as our newest addition to
our paint line. Click here for more information! |
|
|
|
|
 |
|
 |
| Delamination of
texture on drywall surfaces is an expensive and apparently increasing problem. Job site
investigation of this problem reveals not one cause, but
several. Read more >>> |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Hamilton Drywall
Products Prep Coat Plus "Level
5" is our newest addition to our paint
line of products. This product allows the contractor to achieve a level 5 finish as
described in "The levels of Drywall Finish". |
|
 |
Achieve a
level 5 finish as described in "The Levels of Drywall Finish" |
|
|
Used in
lieu of "a thin skimcoat of joint compound" in the level 5 system |
|
|
Save time
and money with a single coat application |
|
|
Low VOC product |
|
|
Low odor |
|
|
Water based
for safe, easy water clean-up |
|
|
 |
|
| Usages:
Prep Coat Plus is designed to be used in lieu of
"a thin skimcoat of joint compound" as described in the "Levels of Drywall
Finish" reported by AWCI and the Gypsum Association. |
|
| Job Conditions:
Minimum temperature of 50 degrees F (10 degrees C)
to be maintained 48 hours prior to application and until "dry" and stable. |
|
| Surface Conditions:
Surface must be thoroughly dry, and free of dust and
foreign substances. Glossy surfaces should be dulled and metal surfaces primed. Particular
attention should be given to metal trims with large exposed surfaces, which ideally should
be primed before the application of Prep Coat Plus. |
|
| Mixing:
Mix by stirring. Power mixing is not recommended. |
|
| Thinning:
Not recommended. |
|
| Equipment:
Airless application is recommended with a tip size
of .019" to .031" at an air pressure between 2700 and 3000 psi. |
|
| Coverage:
Approximately 80-110 square feet per gallon when
applied at 15-20 mils WFT (9-12 OFT). Approximate coverages can vary. |
|
| Drying Time:
When applied in accordance to the directions, Prep
Coat Plus will dry to the touch in approximately 50-60 minutes. |
|
| Clean-up:
Clean tools and equipment with warm soapy water,
rinse with clean water. |
|
| Click here
for the Coat Plus "level 5" submittal sheet. |
|
|
